MODEL TC-10 10″ SLAB/TRIM SAW
This 10" saw makes it easy to trim and slab small rocks. A power feed mechanism makes slabbing especially
easy. For slabbing, secure your rock in the vise, push the button, and the power feed goes from there. You can
slab rocks up to approximately 3 5⁄8" x 6" wide by 6" long. The vise glides smoothly and accurately on two stainless
steel rails. Vice cross feed is 2". The power feed has an automatic shut-off switch for safety. Trimming slabs
is also easy. The arbor is centered on the table so that you can get a 90º perpendicular cut every time. The
stainless steel 5⁄8" arbor shaft has two sealed ball bearings and extra neoprene seal at the tank for extra long
life. The saw table is 13" x 17" with a rim around the edge to contain water and sludge while sawing. The TC-
10 comes with a clear, plastic hood that is easily installed and removed. Splash from the cutting blade is contained
within, but you can easily check your progress through the clear hood. Clean up is easy, too. The table
with vise and switches is hinged at one end, and flips up for access to the coolant tank and sludge removal.
There is also a drain at one end of the tank. Tank and table is durable aluminum construction with impact resistant
finish for long life. Mounted on a 16" x 24" laminated baseboard. This saw requires oil as a coolant. Tank capacity
is approximately one gallon. NOTE: This saw takes a 10" blade with 5⁄8" arbor hole. The Model TC-10 10" saw
is attached to a 16" x 24" laminated baseboard. Overall length of the saw is approximately 30" to include motor
and power feed controls. MODEL TC-10 SLAB/TRIM SAW Comes with 1⁄3 Hp 115V/60Hz motor, power feed,
vise, and see-through hood. (Blade not included.)
Model
1-0164 |
|
Description
MODEL TC-10 10″ SLAB/TRIM SAW |
|
Price
|
|
Qty
|
