Standard Drill Kit
Blocky diamond is bonded to a flexible music
wire providing a positive clearance (kerf). This allows easy drilling without jamming.
This Standard Drill Kit contains one each of the 1mm, 1 1/4mm, 1
1/2mm, 2mm and 2 1/2 mm drills.
IMPORTANT!
Start hole by allowing only a minimum amount of drill tip to protrude beyond the collet or chuck jaws since shank size is only .020.
Once hole is started, adjust drill length as necessary.
Run at 10,000 rpm minimum or more.
Submerge in water or use constant flow.
Use drill press. Hand held tool not recommended.
Use rapid up or down motion when drilling, light to moderate pressure.
IMPORTANT: Always recognize that the drill tip must always have coolant. A combination of excessive speed, pressure, dwell without lifting the drill, will deprive the drill of water and the tip may overheat and poof!
Note: Automatic drills do not have sufficient pressure. Use hand feed.
DRILL BIT SIZE/Collet Size
1.0mm - collet 1/32"
1.25mm - collet 1/16"
1.5mm - collet 1/16"
2.0mm - collet 1/16"
2.5mm - collet 1/16"
Model
1-0506 |
|
Description
Standard Drill Kit |
|
Price
|
|
Qty
|
